Sign in perhaps register 。

Setting requirements: The landing door should be standardized and tooled.Setting requirements: The main connection methods between the wall bracket and the building include: connecting the wall bracket with the embedded parts on the wall; Fix with wall bolts; Embedded bolts; Welding with steel structures.Hyelia,The usual operation of landing and docking. The installation position of the upper limit switch should comply with the following: when the lifting speed is less than .m/s, the upper safety distance L left after the upper limit switch is triggered by the hanging cage should not be less thanSecondly, for the replacement of hydraulic oil on the lifting platform,HyeliaElectric elevator, it is recommended to replace it every three months. If the frequency of use is not high, it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.Bethanie,Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.Model Example: Hanging Cage Specification: LABSC/TDx Type I: ~ Type II: ~ Type V: ~ Technical Requirements: The load-bearing capacity of the foundation should be greater than P: P=(hanging cage weight+outer cage weight+total weight of guide rail frame+counterweight+load) x. (kN).Speed limit wire rope switch. When the speed limit wire rope trips or breaks. Make the electric elevator unable to start.

Chain type electric lifting mechanism: With a good guiding mechanism, it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.And prevent it from starting normally. There should be no device that allows users to cancel warning signals.The foundation base or embedded parts should be fully embedded in the concrete foundation plate.Create brillianceDuring normal operation,HyeliaScissor fork electric lifting platform, the horizontal distance between the closed cage door and the closed landing door should not exceed mm. Otherwise, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed mm.Chain type electric lifting mechanism: With a good guiding mechanism it can ensure that the equipment does not tilt during operation. Gear and rack electric lifting mechanism: precise transmission and high cost.The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.

Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.Total quality management,During the use period, and record the inspection results.When using lifting equipment, the workbench should be kept in a horizontal state.The use of standard section connecting bolts should comply with the user manual and specification requirements.Hyelia,The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, except for the gap between the lower part of the door that should not exceed mm, any through-hole and opening size related to the distance between any door and adjacent moving parts, as well as the gap around the door or the gap between parts, should comply with the provisions of Table of GB -.The verticality of the guide rail frame should meet the requirements of the specifications.