Sign in perhaps register 。

　　It will burn out. If there is a heating problem in use,SteinboliskyQJ submersible pump, you can refer to the following reasons.　　How to avoid this situation when the equipment is in use.Steinbolisky,　　From the working principle, Li is a centrifugal pump. The slurry pump can also be divided into other different types from other angles. Let&#;s see from what angle Panshi pump can classify the slurry pump: first, the suction inlet of the slurry pump　　Submersible slurry pump shaft seal type: packing, packing and auxiliary impeller seal mechanical seal, etc.Kroonstad,　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.　　 Why does the demand for submersible slurry pumps increase greatly? From the perspective of market demand, although the number of submersible slurry pumps has not exceeded that of vertical slurry pumps, the application market of submersible slurry pump is also better than that of vertical pump　　Water flow into the bearing damages the bearing.

　　There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.　　Its working principle is as follows: when the screw pump is working, the liquid is sucked into the sealing cavity formed by the rotor and stator. Due to the rotation of the rotor, the liquid follows the sealing cavity to move along the axial direction from the suction side to the discharge side of the pump, and the continuous suction and discharge realize the liquid transmission .　　Compared with the vertical slurry pump, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump the submersible slurry pump can also be used as a mobile slurry pump, such as sand pumping on board, prospecting, etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pumpHonest management,　　The type selection planning of submersible slurry pump has a great impact on its service life and operation stability. A scientific and reasonable type selection plan will affect whether the slurry pump can achieve efficient operation. The operating power of the slurry pump is very high and the loss is small. Service life of flow passage parts of pump　　In fact, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies, especially in the mining, chemical, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded　　Auxiliary mixing or spraying device shall be equipped for easier operation. When the motor is submerged there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submerged

　　In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved,　　Many users, including new practitioners of slurry pumps, often fail to distinguish the difference between submerged vertical slurry pumps and submerged slurry pumps. The names of submerged and submerged slurry pumps seem similar, but there are essential differences. What is the difference between submersible slurry pump and vertical slurry pump?　　 estimated installation depth of pump M　　It is an auxiliary means for some on-site monitoring.Steinbolisky,　　What should be paid attention to in the process? Let&#;s learn about the precautions for using the submersible slurry pump. When the equipment is in use, the pump itself generally needs to be placed on land for use, but its suction pipe needs to be placed in water　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.　　 If there is abnormal sound inside the slurry pump and there is no water,SteinboliskySplit vertical pipeline pump,SteinboliskyUsed pipeline pump, it is likely that the equipment may have air infiltrating into it when absorbing water, which will cause abnormal sound inside the pump, the impeller is damaged or the impeller is damaged