Sign in perhaps register 。

　　Screw it down, and then remove the bearing inner race, O-ring, shaft sleeve and retaining sleeve in turn.　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.Novi Pazar ,　　Solution: replace the remote pressure gauge; Replace the pressure transmitter; Check the connecting signal wire.　　Screw it down, and then remove the bearing inner race, O-ring shaft sleeve and retaining sleeve in turn.Al Jumum,　　 the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing.　　 selection of raw materials for flow passage parts: the raw materials for flow passage parts of the pump can be selected according to the particle composition, particle size, shape, hardness, concentration, acid, screw down the bolts on the side bearing pressure cap, and then remove the nuts used for the connection between the three parts: discharge section, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleeve

　　Pump. In addition, the submersible slurry pump is mainly characterized by 'slurry', which is wear-resistant and particle passing.　　 use a volt megger to check the insulation resistance, which should not be less than . megohm. If it is lower than this value, open the drain hole and vent hole for drying or drying.　　The input quantity is related to many factors such as the rotating speed of the submersible slurry pump,Novi Pazar Long shaft submerged slurry pump, the bearing standard, the continuous working time, the surrounding environment and the working temperature. Therefore, it is necessary to gradually accumulate the experience and add smooth oil in a reasonable and timely manner.agent,　　 The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage!　　 When adding lubricating oil to the pump at ordinary times, the metering must be controlled, the submersible slurry pump is also a vertical slurry pump, because its axis is basically vertical when it works but it can be completely immersed in water when it runs, so it is a good choice

　　Friction. Because if the surface of the pump is smooth when it is used, the equipment will consume less energy when it is used. Generally, the submersible slurry pump and impeller are sprayed with polymer composite materials for usequery,　　When this type of pump is used at ordinary times, the pump and motor operate in a coaxial whole. When it runs, the motor shaft will drive the impeller of the pump to rotate, and then at this time, the rotating force can be brought to the medium so that　　Fire fighting awareness is deeply rooted in the hearts of the people. With the improvement of fire fighting awareness, many people pay more and more attention to fire pumps. Some places also began to pay attention to the selection of fire pumps. In many places, fire control cabinets are also installed under the full set of fire control systems. In earlier years, fire control　　 We also need to make choices according to local conditions when we make purchases at ordinary times. For example, the head of the centrifugal pump itself is relatively high,Novi Pazar Vertical heavy-duty slurry pump,Novi Pazar Vertical slurry pump, but its water output is not very large when it is used, so it is effective when it is used in many mountainous areasNovi Pazar ,　　The water pump can be used to transport and pressurize clean water without impurities, such as apartment, residence, villa water supply, factory water supply, water supply system, drinking water system and water treatment. In short, there are many uses.　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure, we also need to refer to the instructions when disassembling.　　 Assembly of rotor parts of submersible slurry pump Before assembly, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.